Ford Ranger NEW GEN Stop start off performance module ( Ranger Raptor inc )

Description: Ford Ranger Stop START off kit Click images to enlarge Description Plug-and-play loom to turn off your Stop start from being active until you want it on 1x Original OUTBACK DIESEL STOP START OFF KIT What vehicles does this mod suit? All new-gen Ford Ranger / raptor series About Our Mods: This Australian designed module is made to work with your Ford Ranger and have the stop start in the off position. This product does not create fault codes. Please be aware due to the nature of this product we do not: Warrant any chattel parts of your vehicle. Our warranty is limited to the loom only that we supply. What are the benefits? Less annoyance, less parts wear, less hesitation from stopped position. Is there any supporting modifications required? No. You can fit this on practically any of the applicable models listed. Legalities: This item is designed for Off-street, Off-road or for Racing applications. Please check with your local rules and regulations to see if you can use this product on your vehicle. Installation Basic tools required. Email instructions provided. Installation Difficulty: 1/5 Installation Time: Approximately 10 minutes. If vehicle wiring is dirty - please clean before install! Installation Instructions – Ford Ranger (Gen3 / Next Gen)Stop/Start off installation Step 1:Ensure the vehicle is completely turned off,Get good access to the centre console and lift the trim for the gear stick surrounds from the front using your fingers. Step 2:Find the 12 pin male plug under the STOP/START button area and disconnect it from the switch connector. This is by pushing the small tab in the front-centre of the connector. Step 3:Insert the Ouback Diesel Systems inter-connector part of the loom between the switch and the loom, you should now have no loose wires apart from the RED ignition-on add-a-fuse circuit. Step 4:Push the fuse 2 pin connector down the side of the panel towards the footwell of the drivers side. Pop down the panel using your fingers which is located under the steering wheel. Step 5:Run the red wire towards the fuse panel on the RHS (Where your right knee normally is while driving) and locate the fuse 36 (Usually blue 15 amp). Step 6:Remove the existing fuse, keeping it as a spare, and insert the Outback Diesel Systems fuse connector into the receiver for fuse 36. If it is occupied by another add-a-fuse connection like for CB Radio, you will need to probe for an "Ignition on" source fuse and insert a corresponding fuse in its place into the ODS loom, be mindful that the total load of the fuse gang on the connector cannot exceed 20 amps and you will need to fit the correct fuses accordingly for the circuit. The amperage required at minimum is 5 amps for the ODS stop/start off kit (maximum 15 amps). Step 7:Close up the panels, ensure wiring is tucked away, cable tie wires as needed and replace all panels into their locked positions. Step 8:Start the vehicle and you will see STOP / START has been turned off.The switch will still act as normal, however the starting state is now OFF. How new will the item be? All are new from the manufacturer Where are you located? We are proudly in Brisbane, Australia How will you prepare my package? We take great responsibility in ensuring that your items arrive undamaged and discreetly by wrapping them safely in bubble wrap (where applicable). However if you do need special shipping care or a faster shipping option please let us know in the notes upon purchase. Where do you ship to? We ship international and try to give you the best available rates and shipping options regardless of your location, how much or how little you spend! Track Page Views With Auctiva's FREE Counter

Price: 149 AUD

Location: Mount Duneed, VIC

End Time: 2024-12-02T02:32:50.000Z

Shipping Cost: 31.28 AUD